Charging; Section 5: Adjusting Settings; Adjusting Led Brightness; Turning Wireless Features On/Off - Privoro SafeCase User Manual

CHARGING

Included with the SafeCase
cable, which is USB-A split to Lightning and micro USB,
allowing you to simultaneously charge your SafeCase
and iPhone. To charge the SafeCase, connect it to a
power source (charge-capable USB port or wall charger)
using the charging cable provided, with the micro USB
split connecting to the SafeCase and the USB-A side
connecting to the power source (Figure 36).
Figure 36: Connect the SafeCase to a power source

Section 5: Adjusting settings

ADJUSTING LED BRIGHTNESS

If the corner indicator LEDs or battery status LEDs are
too bright or too dim, you can adjust them or turn them
off. To do so, press the rear button two or more times to
toggle through the three brightness levels: bright, dim and
off (Figure 37). With each press of the rear button, both
the corner indicator LEDs and battery status LEDs will
illuminate to the current brightness level.
Figure 37: Press the rear button two or more times
is a two-in-one charging
TM
While charging the SafeCase, you may also charge
your iPhone by inserting the Lightning split of the
charging cable into the phone's Lightning port.
When first connected to power, the battery status
LEDs will illuminate to indicate the current charge
level (see: Figure 33) for one minute before going
dark. While charging, you can check the charging
status by pressing the rear button (see: Checking
battery status).

TURNING WIRELESS FEATURES ON/OFF

The SafeCase has wireless communication features,
including Bluetooth, WiFi and near-field communication
(NFC); these can be turned off in situations where radio
frequency (RF) emissions are prohibited. To do so, press
and hold both the front and rear buttons simultaneously
for three seconds (Figure 38), until the corner indicator
LEDs start blinking. The corner indicator LEDs will blink
green five times. Once turned off, the corner indicator
LEDs will pulse yellow (to indicate protected mode) or
red (to indicate unprotected mode).
Similarly, to turn the wireless features back on, press
and hold both the front and rear buttons simultaneously
for three seconds, until the corner indicator LEDs start
blinking. The corner indicator LEDs will blink green five
times. Once turned on, the corner indicator LEDs will
resume pulsing green (to indicate protected mode) or
red (to indicate unprotected mode).
Figure 38: Press and hold the front and rear buttons for
three seconds
12