Appendix E: Regulatory Information - Privoro SafeCase User Manual

Appendix E: Regulatory information

FCC COMPLIANCE STATEMENT
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one
of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
CANADIAN REGULATORY
STATEMENT
This device complies with Industry Canada's
licence-exempt RSSs. Operation is subject
to the following two conditions:
(1) This device may not cause interference;
and (2) This device must accept any
interference, including interference
that may cause undesired operation
of the device.
© 2019 PPIP LLC. All rights reserved. PRIVORO and the PRIVORO DOG LOGO are trademarks of PPIP LLC, registered in the U.S. and other countries. PVOSUPJ016V08
In order to comply with FCC/ISED RF
Exposure requirements, this device
must be installed to provide at least
20 cm separation from the human
body at all times.
Le présent appareil est conforme aux
CNR d'Industrie Canada applicables
aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes:
1) l'appareil ne doit pas produire de
brouillage; 2) l'appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Afin de se conformer aux exigences
d'exposition RF FCC / ISED, cet appareil
doit être installé pour fournir au moins
20 cm de séparation du corps humain
en tout temps.
EU COMPLIANCE STATEMENT
Privoro hereby declares that this wireless
device is in compliance with the essential
requirements and other relevant provisions
of the Radio Equipment Directive 2014/
53/EU, as applicable. A copy of the EU
Declaration of Conformity is available
at privoro.com/legal. Legal, regulatory
and compliance documentation is also
available review at the same link.
European Union—Disposal Information
The Wheeled Bin symbol means that
according to local laws and regulations
your product and/or its battery shall be
disposed of separately from household
waste. When this product reaches its
end of life, take it to a collection point
designated by local authorities. The
separate collection and recycling of your
product and/or its battery at the time
of disposal will help conserve natural
resources and ensure that it is recycled
in a manner that protects human health
and the environment.
CLASS 1 LASER INFORMATION
This device is classified as a Class 1
Laser product per IEC60825-1:2007 and
IEC60825-1:2014. This device complies
with 21 CFR 1040.10 and 1040.11 except
for deviations pursuant to Laser Notice
50, dated June 24, 2007. This device
contains a laser that could be damaged
during repair or disassembly, which
could result in hazardous exposure to
infrared laser emissions that are not
visible. This equipment should be
serviced by Privoro or an authorized
service provider.
CLASS 1 LASER PRODUCT
SPECIFIC ABSORPTION RATE (SAR)
CERTIFICATION INFORMATION
This device is a radio transmitter and
receiver. It is designed and manufactured
not to exceed the exposure limits for
Radio Frequency (RF) energy set by the
Federal Communications Commission
(FCC) of the U.S. Government.
These FCC RF exposure limits are derived
from the recommendations of two expert
organizations: the National Council on
Radiation Protection and Measurement
(NCRP) and the Institute of Electrical and
Electronics Engineers (IEEE). In both cases,
the recommendations were developed by
scientific and engineering experts drawn
from industry, government, and academia
after extensive reviews of the scientific
literature related to the biological
effects of RF energy.
The RF exposure limit set by the FCC for
wireless mobile devices employs a unit
of measurement known as the Specific
Absorption Rate (SAR). The SAR is a
measure of the rate of absorption of RF
energy by the human body expressed in
units of watts per kilogram (W/kg). The
FCC SAR limit incorporates a substantial
margin of safety to give additional
protection to the public and to account
for any variations in measurements.
For more information about SAR, visit:
• fcc.gov/general/radio-frequency-safety-0
• fcc.gov/encyclopedia/specific-
absorption-rate-sar-cellular-
telephones
16