Configuring The Card; Serial Data Format; Installation - ABB AS400 User Manual

Input signals
·
Segment 6
User can choose one function for a Segment according to Table 4.
Description
Battery mode shutdown
Any mode shutdown
Emergency power off
Remote On/Off
·
Segment 7
This segment is fixed to "UPS On" function.
Description
UPS On
·
Segment 8
This segment is fixed to "UPS Off" function.
Description
UPS Off
1.4

Configuring the Card

This chapter describes how to install, connect and configure ABB's AS400 Card.
1.4.1

Serial Data format

AS400 Relay Card data has a 2400 baud rate and consist of 1 start bit, 8 data bits, no parity, and 1 stop bit.
BAUD RATE:
DATA LENGTH:
STOP BIT:
PARITY:
Data format figure:
Start
1.4.2

Installation

The card can be installed in UPS equipped with a communication bay without turning off the UPS or
disconnecting the load.
To install the card:
1. Remove the communication bay cover from the UPS keeping the screws for further use.
2. Slide the card into the open slot and fix it with the screws removed in Step 1.
Table 4: Input signal on Segment 6
"1"
ON
Table 5: Input signal on Segment 7
OFF
Table 6: Input signal on Segment 8
2400 band
8 bits
1 bit
NONE
b0 b1 b2
4NWP100446R0001_OPM_ABB_AS400RelayCardPowerValue_EN140226
Modifications reserved
"1"
Only Battery mode
shutdown
Shutdown
OFF
OFF
"0"
Normal
"1" "0"
Normal
b3 b4 b5
"0"
Normal
Normal
Normal
ON
b6 b7 Stop
Page 8/15 ABB