Winnebago Adventurer 27N Manual page 68

SECTION 6 -
ELECTRICAL
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Connecting the Power Cord
To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable power outlet to provide external power
to the motorhome and converter/charger system.
Your motorhome may be equipped with either
a standard 30-amp system or an optional 50-amp
system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
If your motorhome is equipped with
standard 30-amp system, you cannot
connect to a 50-amp service. Do not use
adapters to connect 30-amp systems to a
50-amp service or you may cause an
overload on electrical system
components.
30 Amp Receptacle
WARNING
This connection is for 110/125 Volt AC,
60 Hz 30 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
6-2
Power Receptacle
WARNING
This connection is for 208Y/120-Volt or
120/240 Volt AC, 3-pole, 4 wire, 60 Hz
50 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
A rotating hatch in the compartment floor lets
you route the shoreline cord through a passage in
the bottom of the compartment so you can shut
the compartment door while the shoreline is
connected.
1. Flip the retainer in the center of the cover
straight up.
2. Rotate the cover to the largest hole to pass the
cord end through.
50 Amp.