3Rw402 - 3Rw404, Control Of A Motor With A Magnetic Parking Brake - Siemens SIRIUS 3RW30 Manual

16.8.2

3RW402 - 3RW404, control of a motor with a magnetic parking brake

Figure 16-21 Emergency stop wiring of the 3RW402 - 3RW404 control circuit / main circuit
(1) For permissible main and control voltage values (dependent on article number), refer to
chapter Technical data (Page 127).
(2) Automatic restart. Can result in death, serious injury, or property damage.
The start command (e.g. issued by the PLC or switch S1) must be reset prior to issuing a
RESET command because the motor attempts to restart again automatically following this
RESET command if a start command is still present. This particularly applies if the motor
protection has tripped. For safety reasons, you are advised to integrate the group fault
output (terminals 95 and 96) in the controller.
(3) Alternatively, the motor feeder can be assembled as a fuseless or fused version with type
of coordination 1 or 2. For the assignment of fuses and switching devices, refer to chapter
Technical data (Page 127).
For the optional thermistor motor protection evaluation, refer to Typical circuit for the optional
thermistor motor protection evaluation (Page 161).
Note
No soft stop possible. Set the stopping time to 0 s with the potentiometer.
SIRIUS 3RW30 / 3RW40
Manual, 10/2018, NEB535199502000/RS-AB/005
WARNING
Typical circuit diagrams
16.8 Control of a magnetic parking brake
181