Function Of The Failure / Overload Output - Siemens SIRIUS 3RW30 Manual

E: Exit programming and save the settings:
Press the RESET / TEST MODE button (1) for longer than 1 s until the DEVICE LED (3)
lights up (green).
The LEDs indicate the following states again if the output was successfully parameterized:
DEVICE LED: Continuously lit (green).
STATE / BYPASSED and FAILURE LEDs: Off.
The AUTO LED indicates the color of the set RESET mode.
13.7.3

Function of the FAILURE / OVERLOAD output

FAILURE / OVERLOAD output contact
If there is no rated control voltage or if a failure occurs, the potential-free FAILURE /
OVERLOAD output is switched.
Note
For information about whether or not faults can be acknowledged, as well as the recovery
time and the corresponding LED and output contact states, refer to chapter Messages and
diagnosis (Page 57).
SIRIUS 3RW30 / 3RW40
Manual, 10/2018, NEB535199502000/RS-AB/005
Commissioning
13.7 Functions of the outputs
125