Philips FTP1.1E Service Manual page 18

EN 18 4. FTP1.1E
3
6
2
Figure 4-5 SSB Box. Front view
1. Release the AC input cables from the Plasma Panel and
SSB.
2. Remove the two mounting screws (1) at the both sides of
the SSB Box.
3. Remove all mounting screws (2) at the front side of the
SSB Box.
4. Remove all metric screws (3) at the front side of the SSB
Box.
5. Remove all parker screws (4) at the front side of the SSB
Box.
6. Use a hex nut driver or pliers to remove both connector
fixing screws (5) by the VGA connector.
7. Remove the two silver coloured metric mounting screws (6)
by the mains cord.
8. Carefully turn upside-down the SSB Box. Remove the two
mounting screws at the bottom side of the SSB box.
9. Turn the SSB Box back to the initial position. Release
plastic clamps (7) at the topside of the SSB Box (see figure:
"SSB Box. Top view"). Carefully use a flat screwdriver to
release the metal clamps at the both sides of the SSB Box.
Lift the shielding cover of the SSB Box.
SSB removal
2
Figure 4-6 SSB removal
1. Release all cable from the SSB.
2. Remove all mounting screws from the SSB (1).
3. Remove the SSB.
Mechanical Instructions
4 5
3
CL 36532075_052.eps
181103
1
CL 36532075_054.eps
181103
4.2.3
Audio Amplifier Panel
TWEETER LOUD SPEAKERS
MAIN
SWITCH
PANEL
Figure 4-7 Speaker and panel removal
1. Disconnect all cables from the panel.
2. Remove the fixing screws from the panel.
3. Remove the panel.
4.2.4
EMC Interface Panel and Main Switch Panel
See figure "Speakers and panels removal".
Note: Before removing the EMC Interface Panel and Main
Switch Panel you have to remove the plastic rear cover.
1. Remove all T10 parker screws (6) around edges of the
plastic rear cover, some of them are indicated on figure
"Rear cover removal".
2. Disconnect all cables from the panels.
3. Remove the fixing screws from the panels.
4. Remove the panels.
4.2.5
Plasma Panel
Make sure, that the power is switched "off" and that the
necessary cables are disconnected.
Note: Before replacing the Plasma Panel, first remove SSB
Box, Audio Amplifier Panel and EMC Interface Panel, as
described above.
1. Remove the four PDP brackets, two of them are indicated
(9) on the figure "SSB Box. Top view".
2. Remove all fixing screws from the Shielding Frame. Lift
and remove the Shielding Frame.
3. Remove all fixing screws from the Plasma Panel. Lift and
remove the Plasma Panel.
4.3
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Note: While re-assembling, make sure, that all cables are
placed and connected in their original position
AUDIO
AMPLFIER
PANEL
EMC PANEL
CL 36532075_055.eps
181103