Mechanical Instructions - Philips FTP1.1E Service Manual

4. Mechanical Instructions

Index of this chapter:
1. Service Positions
2. Assy / PWB Removal
3. Re-assembly
Notes:
•
Figures below can deviate slightly from the actual situation,
due to the different set executions.
•
Follow the disassemble instructions in described order.
4.1
Service Positions
4.1.1
The Foam Bars
Figure 4-1 Foam bars
To put the TV set in its service position place it upside down on
a table top, use foam cushions or a protection sheet.
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of Flat TVs. By laying the plasma
or LCD TV flat on the (ESD protective) foam bars, a stable
situation is created to perform measurements and alignments.
By first placing a mirror flat on the table under the TV you can
easily see if something is happening on the screen.
Caution: When using a sheet, the plasma screen can become
very hot. Therefore, it is advised to use foam cushions
4.1.2
The Aluminium Stands
Figure 4-2 Aluminium stands
The aluminium stands (order code 3122 785 90480 for two
pieces) can also be used to do measurements and alignments,
also they are very suitable to perform duration tests. With this
stands the set does not take much space, has no risk of over
Mechanical Instructions
CL 36532051_002.eps
190603
CL 36532051_001.eps
040703
FTP1.1E
heating, and/or falling. The stands can be mounted and
removed quickly and easily with use of the provided screws,
which can be tightened and loosened manually without the use
of tools.
The stands are also handy to replace the screen.
Caution: Only use the screws provided, otherwise it is possible
to damage the monitor inside.
4.2
Assy/PWB Removal
4.2.1
Metal Back Plate
Warning: Disconnect the mains power cord before you remove
the rear cover.
4
6
Figure 4-3 Rear cover removal
Notes:
•
It is not needed to remove the T8 screws (1) around and
above the "stand holes".
•
It is also not needed to remove the T8 screws (2) around
the SSB outer box.
1. Remove all T10 metric screws (3) from the centre part of
the metal back plate.
2. Remove all T10 parker screws (4), some of them are
indicated on the figure above.
3. Remove two T20 screws (5).
4. Lift the metal back plate from the cabinet. Make sure that
wires and flat foils are not damaged during cover removal.
4.2.2
Small Signal Board
Small Signal Board (SSB) Box disassembly
Figure 4-4 SSB Box. Top view
4. EN 17
8x 8x 8x 8x
1
5
2
4
3
CL 36532075_051.eps
7
8
1
9
CL 36532075_053.e
181103
1811