Miele CS 1028 G Operating And Installation Instructions page 43

Connecting the ProLine
element
 Connect the ProLine element/
elements to the electrical supply and
to the gas supply (see "Electrical
connection" and "Gas connection").
Checking operation
 After installation, ignite all burners to
check that they are operating
correctly:
– The flame must not go out on the
lowest setting, or when the control is
turned quickly from the highest to the
lowest setting.
– On the highest setting, the flame
must have a distinctive and visible
core.
Removing a ProLine element
 If the ProLine element is accessible
from below, push it upwards to
remove it. Push the back of the
appliance out first.
 If the ProLine element is not
accessible from below, take hold of
the appliance with both hands at the
back, pull it forwards, then lift it up
and out.
Installation
43