Honda ACTIVA 4G 2017 Owner's Manual page 54

Front Wheel Installation
1. Position the wheel between the fork
legs and insert the front axle from the
left side, through the left fork leg, front
brake panel, wheel hub, collar and right
fork leg.
Make sure that the tang (13) on the left
front fork leg is located in the slot (14)
in the brake panel.
2. Tighten the front axle nut to the
specified torque.
59 N.m (6.0 kgf.m, 43 Ib f. ft)
3. Install speedometer cable, brake cable,
brake arm joint, brake adjusting nut,
brake arm joint spring in the reverse
order of removal
(13) Tang (14) Slot
¼VS a x ½
50
ACTIVA 4G
(14)
(13)
¼LykV½
4. Adjust the brake (page 11 - 13).
5. After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Rear Wheel Removal/Installation
1. Place the vehicle on its center stand.
2. Remove the rear wheel nut (1) and
washer (2) by applying rear brake
3. Remove the rear wheel.
4. Installation is in the reverse order of
removal
(1)
(2)
(1) Nut ¼uV½
(2) Washer ¼ok"kj½
Honda Motorcycle & Scooter India Pvt. Ltd.