Table of Contents
Advertisement
Message
NON-VOLATILE RAM FAILURE (97)
CALL SERVICE – PRESS ENTER TO
CONTINUE
NO RESPONSE FROM KEYPAD A (B) (78)
PRESS ENTER TO CONTINUE
NO RESPONSE FROM INPUT A (B)
PERFORMING CALIBRATION
PERFORMING SELF-TEST
POWER DISTRIBUTION FAILURE (49)
TURN OFF IMAGER – CALL SERVICE
PRINT JOB LIST FULL (86)
PRESS ENTER TO CONTINUE
REGULATING TEMPERATURE
REMOVE FILM FROM EXIT AREA (28)
INSERT FILM SAVER TO REMOVE FILM TRAY
REMOVE FILM SAVER (31)
REMOVE FILM TRAY (40)
REMOVE, LOAD, AND INSERT FILM TRAY (12)
REMOVE, LOAD, AND INSERT FILM TRAY (30)
PRESS ENTER WHEN READY TO REMOVE
TRAY
2000 March Rev. B
8186546
Section 5 – Troubleshooting
Operator Action
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
None.
None.
Power imager off, wait 10-20 seconds,
then power back on. If message
reappears, call for service.
Wait until some films have printed
before sending more images to print.
Imager adjusting temperature. If not
completed in 45 minutes, call service.
Insert the film saver. Raise the cover
and remove film from the exit area.
Close cover and remove the film saver.
Press Enter to continue.
Remove the film saver from the tray.
Insert film saver and remove film tray.
Remove the film tray, load film, and
re-install the film tray.
Press Enter. Remove the film tray, load
film, and re-install the tray.
5-5
Advertisement
Table of Contents
