Ordering Instructions; Repair/Upgrade - Siemens LDS 6 Operating Instructions Manual

Please note that three of the LDS 6 sensor electronic spare parts are version-dependent.
(The PCBs are not affected but detector electronics are different).
Table 7- 6
Product description
LDS6, Barrier box 1 channel
LDS6, Barrier box 2 channels
LDS6, Barrier box 3 channels
CD 6, Sensor electronic ATEX SW
CD 6, Sensor electronic ATEX HCl
CD 6, Sensor electronic ATEX NH
CD 6C and FT 6, Sensor electronic lppm H
Window module, quartz, ATEX CD 3002
LDS6, Entry seal for barrier box
See also
List of Abbreviations (Page 95)
7.3

Ordering Instructions

All orders should specify the following:
1. Quantity.
2. Product description.
3. Order number.
4. MLFB number and serial number of the instrument to which the spare part will be used.
5. For sensor electronics, A5E and revision numbers of the detector to be replaced
7.4

Repair/Upgrade

Faulty equipment should be sent to the repair department with details of the fault and its
origin. When ordering replacement equipment, please specify the serial number of the
original equipment. Your will find the serial number on the rating plate.
Address of the responsible repair location, your contact, list of spare parts etc. can all be
found on Internet:
http://www.siemens.com/automation/service&support or
http://www.automation.siemens.com/partner
LDS 6
Operating Instructions, 01/2009, A5E00295894-05
Spare parts ATEX
, CO, CO
3
, HF, H O
2 2
O ATEX
2
Spare Parts List
7.3 Ordering Instructions
Order no.
A5E00902922
A5E00902926
A5E00902927
A5E00338563
A5E00853896
A5E00338572
A5E00924868
A5E00338594
A5E00979661
81