Siemens LDS 6 Operating Instructions Manual page 45

Entry into Main Menu for a
1- or 2-Channel System
Figure 4-2
Entry into Main Menu for a
3-Channel System
LIM STO CTRL TR
3
11.28 mg/Nm
11.13 %
LIM STO CTRL TR
12.53 mg/Nm 3
10.13 %
LIM STO CTRL TR
5.28 mg/Nm 3
15.13 %
Channel 1
11.28
mg/Nm 3
11.13
%vol
LIM STO CTRL TR
Main Menu
Main Menu Ch1 NH3
Analyzer Status
Calibration
Measuring Range
Parameters
Configuration
Entering a Submenu
Following the selection of a submenu, you will be asked to enter a password for service
mode ② (exception: submenu "Analyzer status" which requires no password and is thus
freely accessible).
Analyzer status
Calibration
Measuring ranges
Parameters
Configuration
The passwords for levels 1 and 2 are factory-set to the values "111" and "222" respectively.
LDS 6
Operating Instructions, 01/2009, A5E00295894-05
Input sequence interacting with LDS 6
The appearance of the screen menu varies depending on the number of channels and the
number of measured components. For a 3-channel system the soft keys of the measuring
screen are assigned to channels instead of measured components. If the channel has two
CODE
components it is necessary to pass a second channel-specific measuring screen before entering
NH
3
the component-specific main menu.
Ch1
CODE
NH
3
Ch2
CODE
NH
3
Ch3
Each channel can be operated independently.
NH
3
H O
2
CODE
The main menu consists of the five items shown in the adjacent screen.
Whilst in Measuring Mode, the component is shown on the right, with
an arrow ( ). A soft key ① is assigned to this specific component and
it is called by pressing it.
No code
Access level 3
Access level 1
Access level 1
Access level 2
Operation
4.2 Input Sequence of Data
45