Switch Action - Makita HS7010 Instruction Manual

► 1. Clamping screw
Sighting
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
45° position with it.
For HS7010
► 1. Cutting line (0° position) 2. Cutting line (45°
position)
For HS7610
► 1. Cutting line (0° position) 2. Cutting line (45°
position)

Switch action

WARNING:
always check to see that the switch trigger actu-
ates properly and returns to the "OFF" position
when released.
WARNING:
by taping down or some other means. A switch with
1
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
2 1
► 1. Switch trigger 2. Lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
depress the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
NOTICE:
without pressing in the lock-off button. This can
cause switch breakage.
2 1
ASSEMBLY
CAUTION:
switched off and unplugged before carrying out
any work on the tool.
Removing or installing circular saw
blade
CAUTION:
installed with teeth pointing up at the front of the
tool.
CAUTION:
install or remove the circular saw blade.
1.
To remove the circular saw blade, press the shaft lock
fully so that the circular saw blade cannot revolve and use
the hex wrench to loosen the hex bolt counterclockwise.
7 ENGLISH
Before plugging in the tool,
NEVER defeat the lock-off button
NEVER use the tool if it runs when
1 2
Do not pull the switch trigger hard
Always be sure that the tool is
Be sure the circular saw blade is
Use only the Makita wrench to