Table of Contents
Advertisement
CONSTRUCTION OF COMPOSITIONS
Each one of the input HotFolders has its own image constructor parameters. The image processor uses these
parameters to build the image to be printed.
The construction of the image is based on a canvas concept. The SmartD90EV's image processor creates a
solid surface base on where the different layers that will create the final image are painted following a
certain order. The availability of some layers depends on the selected service mode and the settings of the
HotFolder used by the service selected.
Each layer has its own group of settings that can be adjusted from the SmartD90EV's maintenance
application.
All the layers are referenced to the upper left corner of the base canvas, being this point the 0,0 coordinate.
In order to create a correct final image, all the layers have to be equally sized.
The image/photo layer has four parameters for the image constructor: X, Y W, H. The values must be in
pixels and defines the are where the image will be fitted. If these values are blank, the image/photo will
match the canvas size.
Canvas X = 0
Canvas Y = 0
X
Y
W
5
Canvas
H
Height
i
Advertisement
Table of Contents
