3.
Data Transfer
3.1.
Data Transfer Mode
FDP03 has 2 kinds of data transfer mode. One is "Interchange" mode that is
possible to exchange data between other FDP series. Another is "Communication
Distance Extend" mode. The initial setting is "Interchange" mode.
3.2.
Setting
3.2.1. Setting by the memory register
The data transfer mode can be changed by the bit 5 of the REG10. The initial
setting of the bit 5 is "0". It means that "Interchange" mode. For more detail, please
check Section 8.
3.2.2. Setting by command
The data transfer mode can also be changed by SPD command. For more detail,
please check Section 9.3.
3.3.
Difference of 2 modes
Interchange Mode
Communication Distance
Extend Mode
The data transfer mode should be same setting among
communication partners. If the mode is different each other,
it is impossible to communicate with.
It is possible to communicate between
other FDP series such as FDP01 and
FDP02.
Wireless communication distance is
extended to twice as long as
"Interchange" mode.
7
Ver.1.0