Rf Circuit Power Control Mode; Operation Flow - FUTABA FDP03TJ010 Instruction Manual

6. RF Circuit Power Control Mode

This mode can realize low power consumption operation by stopping RF circuit.
6.1.

Operation Flow

It is possible to control ON/OFF of RF circuit by ROF/RON command. For more detail of ROF/RON
command, please check "Commands" section below.
Current Consumption
ROF Command RON Command
RF OFF
Wireless communication is completely cut when RF circuit is OFF. Therefore,
RON command should be executed to turn ON the RF circuit if wireless
communication is returned.
If the FDP03 is re-booted and/or the operation mode is returned from "Power
Down" mode, the RF circuit will be turned ON. Thus, it is necessary to execute
ROF command to cut the RF circuit again.
15
ROF Command
RF ON RF OFF
Ver.1.0