Table of Contents
Advertisement
9.3 Commands
The host system communicates to the FDP03 by below command.
9.3.1 List of commands
The table below shows the commands.
Command
ARG
BCL
DAS
FNU
FRQ
IDR
IDW
INI
RST
REG
POF
PON
PTE
PTN
PTS
ROF
RON
SPD
TBN
TID
TS2
TXT
VER
9.3.2 Command input format
The input format of a command is as follows:
@xxxx<Cr><Lf> @: Command header
xxxx: Command code
<Cr>: Carriage return code
<Lf>: Line feed code
Function
Show the settings of all registers.
Clear transmission and reception buffers.
Show/set the destination address.
Show/set the frequency group.
Show/set the frequency channel.
Show ID code
Set ID code
Initialize all memory registers.
Reset the FDP03.
Show/set the memory register
Release low power stand-by mode
Set low power stand-by mode
Show/Set extended stand-by time
Show/Set stand-by time
Show/Set sleep time
RF circuit OFF
RF circuit ON
Show/set data transfer mode
Transmit binary data.
Show the serial number.
Execute a communication test.
Transmit text data.
Show version information.
If multiple commands are entered continuously, the commands that are entered
before the response from the FDP03 is ignored. Therefore, it should be entered
after the FDP03 returns a response for previous command.
Groups (1 to 3)
Frequencies (02 to 77)
REG00 to REG26
Transfer mode (1 or 2)
29
Ver.1.0
Remark
Advertisement
Table of Contents
