Dorel Juvenile Group Scenera Instructions Manual page 29

4358-5405 Can Scenera 12/8/10
6.
2
1
7.
55
2:50 PM Page 57
Pull Vehicle Latch
Plate Across to
Opposite Side
Reach under pad and pull
the vehicle belt across the
shell and out the rear-
facing belt path on
opposite side. Buckle
vehicle belt. Vehicle belt
MUST be under pad and in
front of buckle/crotch
strap. Do not place
vehicle belt over
infant's legs.
NOTE: You must use the
1st or 2nd buckle/crotch
strap slots when rear-
facing.
Tighten Vehicle Belt
Push down firmly on the
infant restraint and pull on
the vehicle shoulder belt
or lap belt to tighten.
With a switchable
retractor, feed the
shoulder belt back into the
retractor while tightening.
It maybe easier to tighten
the belt through the belt
path opening as shown.
8.
Check Vehicle Belt
Tightness
Grasp the infant
restraint at the belt path
with one hand. Push and
pull the infant restraint
from side to side, forward
and back. The infant
restraint should not move
more than 2.5 cm (1 in)
and the vehicle belt should
not loosen.
NOTE: If it moves more
than an 2.5 cm (1 in.) or if
the vehicle belt loosens, try
reinstalling the infant
restraint or try another
seating location.
Secure your infant in the
infant restraint.
56