Dorel Juvenile Group Scenera Instructions Manual page 22

4358-5405 Can Scenera 12/8/10
10.
11.
12.
NOTE: If it moves more than 2.5 cm (1 in.) or if the vehicle belt
loosens, try reinstalling the infant restraint or try another seating
location. If you still have questions after installing the locking
clip please contact our Consumer Relations department.
Remove the locking clip when the vehicle seat belt is not
being used with a restraint system.
41
2:50 PM Page 43
Position Locking Clip
Position locking clip about
2.5 cm (1 in.) from vehicle
belt's buckle plate.
Rebuckle Vehicle Belt
Check Vehicle Belt
Tightness
Grasp the infant restraint at
the belt path with one hand.
Push and pull the infant
restraint from side to side,
forward and back. The
infant restraint should not
move more than 2.5 cm
(1 in.) and the vehicle belt
should not loosen.
E Installing on Aircraft
This restraint system is
certified for aircraft use.
Use only on forward-facing
seats and in a position
where the seat belt can be
tightened securely. The
installation is the same as in your vehicle. Use only with F.A.A.
certified equipment. Contact the airline before taking the
infant restraint on an aircraft in order to comply with their
regulations.
E-1 Install Rear-Facing with Aircraft
Belts
1. Secure UAS Belts
You MUST attach the UAS
belt hooks to the side of
shell as shown when
using the aircraft seat
belts.
2. Fold the Recline Stand
Under the Infant
Restraint
2
1
3.
Secure Tether Hook
You MUST attach the
tether hook to the recline
stand as shown. Tighten
tether to remove the
slack.
42 continued on next page.