Dorel Juvenile Group Scenera Instructions Manual page 26

4358-5405 Can Scenera 12/9/10
F-2 Preparing UAS for Rear-Facing
Use
1.
2.
3.
2
1
under pad and in front of buckle/crotch strap.
Do not place UAS belt over infant's legs.
NOTE: You must use the 1st or 2nd buckle/crotch strap slots
when rear-facing.
4.
49
1:37 PM Page 51
Routing UAS Belt
Insert the UAS hook with
adjuster through the
forward-facing belt path.
Adjuster
Reach under pad, pulling
UAS hook and adjuster
between right lower harness
slot and buckle/crotch strap.
Pull UAS out the rear-facing
belt path.
Pull Other UAS Hook
Out the Opposite Side
Reach under pad and pull
the other UAS hook across
the shell and out the rear-
facing belt path on opposite
side. UAS belt MUST be
Finished UAS Routing
Make sure the UAS belt is
not twisted.
F-3 Install Rear-Facing with UAS
Note: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only if the
belt can be tightened properly and securely.
Attach the tether hook to the recline stand when
used rear-facing.
Do not fasten both UAS hooks on the same UAS
anchor bar in the vehicle.
Do not recline the infant restraint beyond the
level-to-ground line. Use only the reclined
position. Do not use the recline stand when
rear-facing.
Failure to follow these warnings can result in
serious injury or death.
1. Fold the Recline Stand
Under the Infant
Restraint
2
1
2.
Secure Tether Hook
Attach the tether hook to
recline stand as shown.
Tighten tether to remove the
slack.
50
continued on next page.