Configuring The Remote Alarm Box - Zte Alarm Box User Manual

3.
Follow-Up
Generally, the remote alarm box and the alarm server reside in different
network segments. For how to configure the remote alarm box, see 6.2.3.

6.2.3 Configuring the Remote Alarm Box

Purpose
You need to telnet the alarm box from a PC that resides in the same network
segment with the alarm box. Then configure the TCP or UDP connection on the
alarm box. Moreover, routing information should be configured on the alarm
server. The routing information can be saved in the flash so that it will not be
cleared upon restart of the alarm box.
Prerequisites
Steps
1.
Run the ping command to check the connectivity between the alarm box
and the server.
The IP address of the PC connected to the alarm box is already

configured.
TCP port 6700 is configured on the alarm server if the alarm server

interacts with the alarm box through TCP.
UPD port is configured on the alarm box if the alarm server interacts with

the alarm box through UDP. The default port 5000 is used in this
example.
You have telneted the alarm box from the PC. For details, see 5.2.

Configure the alarm server 193.232.54.129 in the alarm box.
In the case of TCP, run the following command:

601> cfgTcpComm 3 193.232.54.129 6700 3
************************************************************
TcpServer1 Set succeed !!!
************************************************************
In the case of UDP, run the following command:

Chapter 6 Alarm Box Networking
6-5