Section 2 - OPERATING INSTRUCTIONS
WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP
engine and blade. Disconnect spark plug wire and
secure away from spark plug. Engine and compo-
nents are HOT. Avoid serious burns, allow suffi-
cient time for all components to cool.
2.6 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move to
desired cutting height. See Figure 2.10.
!
WARNING
Stop engine and mower blade by releasing the
blade control before adjusting cutting height.
5
6
7
HIGHEST
CUTTING
HEIGHT
6
7
HIGHEST
CUTTING
HEIGHT
FIGURE 2.10
2. Set all wheels at the same cutting height. The high-
est cutting position is Notch 7. The lowest cutting posi-
tion is Notch 1. See Figure 2.11.
1
2
3
LOWEST CUTTING
4
HEIGHT
LATCH (IN
NOTCH # 4)
FRONT WHEEL
(EXCEPT SPV211S)
3
4
2
LOWEST
1
5
CUTTING
HEIGHT
LATCH (IN
NOTCH # 4)
REAR WHEEL
(SPV211S FRONT
WHEEL SIMILAR)
EACH NOTCH RAISES CUT 0.5"
!
LATCH
POSITIONS
1.2"
2.7 RECYCLING OPERATION
NOTE: For best recycling results, cut up to a maximum of
!
1/3 of grass blade length and recycle ONLY when grass is
dry.
1. Set all wheels in the highest cutting position (Notch
7). Refer to Section "Cutting Height Adjustment".
2. Move engine speed control to "FAST" (Rabbit) posi-
tion.
3. Move ground speed control to slowest speed set-
ting.
4. Proceed mowing slowly. If grass is very dense,
lower each rear wheel latch one notch lower than the
front wheel latches to improve recycling performance.
NOTE: The recycling cover should remain on the
machine at all times, unless alternate discharge opera-
tions are desired, such as side discharging or bagging.
TO REMOVE RECYCLING COVER:
Remove knob nuts and internal/external tooth lock washers
securing recycling cover to mower deck. Remove cover.
See Figure 2.12.
9
CUTTING HEIGHT SETTINGS
FIGURE 2.11
REMOVE KNOB NUTS
AND LOCK WASHERS
FIGURE 2.12
4.2"