Preparation Before Use; Installing The Battery - AND MPA-10 Instruction Manual

7. PREPARATION BEFORE USE

7-1 Installing the battery

1. Remove the battery cover (2) by sliding it upward while pressing and holding the
battery cover release button (1).
2. Connect the terminal of the battery's cable, as shown in the figure below, to the
connector for the battery in the bottom of the battery compartment. When
connecting the terminal, be sure it is connected in the proper direction.
3. Install the battery so that the battery cable is in the cable guide.
4. Attach the battery cover on the pipette by sliding it downward from the upside.
Battery cover
release button
1. Open the battery cover.
Cable
3. Install the battery.
Note
When connecting the battery to the pipette, all illuminations on the
display illuminate and the pipette built-in piston automatically goes to the
initial default position. If a key is pressed, the pipette goes into the
operating mode.
(2)
Battery cover
(1)
Cable guide
Expanded
2. Connect the battery connector.
4. Attach the battery cover.
10
Black
Red
Battery connector