Parameter 2 Of Catchweigher - Yaohua Weighing System XK3190-C602 User Manual

X K 3 1 9 0－C 602
(when 【SET 1】 parameter 13A is set as 2 or 3 in table 4-3)
Para
Indicator
mete Parameter explanation
display
r
A—catchweighing mode
[
A]
1 (0: non-peak hold, 1: peak
[CtrL ]
hold)
Upper limit of channel 1:
[******]
If "zero zone" ≤X＜A, the
2
[A ]
indicator outputs signal of
channel 1 at t3.
Upper limit of channel 2:
[******] If A≤X ＜ b, the indicator
3
[b ] outputs signal of channel 2 at
t3.
Upper limit of channel 3:
[******] If b ≤X ＜ C, the indicator
4
[C ] outputs signal of channel 3 at
t3.
Upper limit of channel 4:
If C≤X ＜ d, the indicator
outputs signal of channel 4 at
[******]
5 t3.
[d ]
If X ≥d, the indicator will
output signal of channel 5 at
t3.
Zero zone:
1.
catchweighing signal, it will
not enter the next cycle until
the weight
indicator is below this value;
[******]
6 2. Under self-control mode, it
[0_Zone]
will not enter t1 until the
weight
indicator is above this value.
3. If X is below zero zone,
the indicator will not output
channel signal at t3.
Table 4-5 Parameter 2 of Catchweigher
Refer to note of parameter 8
for meaning of X. Same for
below.
After sending
measured by
measured by
Remarks