Sd Card; I/O Wiring - red lion Sixnet Series Hardware Manual

Cellular rtus

Hide thumbs Also See for Sixnet Series:

Table of Contents

Hardware Installation

Revised 2015-07-16

SD Card

The RAM 9000 has an SD memory card socket. This socket is found under a small door in the front face of the unit.

Remove the one screw to access the SD card socket. To install an SD card, insert in the orientation show on the

label until you hear a click. The SD card when properly inserted should sit just behind the door as shown below. To

remove the SD card push on the card until you hear a click, then remove pressure and the card will release.

Note: A future firmware update is required to utilize the SD Card feature. Contact Red Lion for availability of this

feature.

The RAM-96xx, RAM 97xx, and RAM-99xx models offer 2 discrete inputs, 2 discrete outputs, 1 relay output and 3

analog inputs. The discrete inputs and outputs operate on the same voltage as the unit which is 8-30 VDC. The

relay output can switch an external power source up to 125 VAC. The analog inputs can accept current(0/4-20 mA)

or voltage (0-10 VDC) inputs. The range is selectable in the software configuration.

The pluggable screw block terminal is provided for the I/O wiring connections. Refer to the diagrams below on

how to make your I/O connections.

Notes:

• For relay wiring, use a minimum of 300V, 90°C rated wiring. Note: For ATEX / IECEx purposes, the relays are not

applicable.

• Terminals are sized to hold 28 to 12 gauge wire, 12 AWG wire area is 3.31mm2.

• Torque spec for terminals is 0.5 Nm.

• Use copper wire rated to 90°C or above.

RAM 9000 Series Hardware Guide

2-41

Table of Contents