Indicator Lights - red lion Sixnet Series Hardware Manual

Product Overview
Specifications

Indicator Lights

LED
P1
P2
(Backup Power)
SD
GPS
WAN
RSSI
Reset
Status
Ethernet Link and
Activity
(Yellow)
Ethernet Speed
(Green)
RS485
RS232
RLY1
RAM 9000 Series Hardware Guide
STATUS
ON Power is being applied to the primary input
OFF Power is not being applied to the primary input
ON Power is being applied to the secondary input
OFF Power is not being applied to the secondary input
ON SD Card mounted
OFF No SD Card mounted
ON Position fix available
OFF No position fix available
ON Cellular connection is established
OFF Cellular connection is not established
Low Signal / No service
> - 109 dBm (Low but valid signal)
> - 99 dBm (Lower but valid signal)
> - 89 dBm (Avg signal)
> - 80 dBm (Excellent signal)
Unit is booting. Not ready.
ON
Unit is functioning normally
OFF
Unit is booting up.
ON
Normal operation
OFF
Unit entering reflashing mode. Do not disturb.
FLASH
STROBE (Fast
System error. Contact Red Lion Technical Support.
Flash)
Link detected
ON
No link detected
OFF
Linked and active communications detected
FLASH
100 Mbps link speed detected
ON
10Mbps link speed detected
OFF
Serial connection is configured for use
ON
Serial connection is not configured for use
OFF
Serial connection is established – with no data activity with host
ON
Serial connection is not established
OFF
Serial connection is established – with data activity with host
SLOW FLASH
STROBE (Fast
Unit is reflashing. Do not disconnect power!
Flash)
The relay output is being activated. The Normally Open terminal
will be ON (closed). The Normally Closed terminal will be OFF
ON
(open)
The relay output is not being activated. The Normally Open terminal
will be OFF (open). The Normally Closed terminal will be ON
OFF
(closed).
CORRESPONDING STATE
Revised 2015-07-16
5-22