Table of Contents
Advertisement
Hardware Installation
Battery
Note: The unit may ship with a battery pull-tab insulator in place that prevents the battery from discharging prior
to first use. Remove the insulator when you are ready to install and use the unit. The insulator is removed by sim-
ply pulling it out.
Note: The battery does not provide power to the unit either as a main power source or as a backup. It only powers
the SRAM memory and real-time clock, and only when there is no power supplied to either P1 or P2.
Note: For full temperature ATEX and/or IECeX compliance you must use a battery rated to 125C such as the Pana-
sonic BR1225A/BN.
Battery Removal and Installation:
Step 1: Open Battery door on bottom of unit by removing the single screw.
Step 2: Insert a small flat-head screwdriver into the slot as shown below:
Step 3: Leverage back on the handle of the screwdriver to pop out the battery assembly:
RAM 9000 Series Hardware Guide
Revised 2015-07-16
2-39
Advertisement
Table of Contents
