Omron E5CC Solution Manual page 24

Setting Temperature Alarms
Setting the Hysteresis
2
You set this parameter in the Initial Setting Level. The parameter is set to 0.2°C by default.
1
Turn ON the power supply.
2
Press the K ey for at least 3 seconds.
Press the
for at least 3 seconds.
3
Change the parameter with the
Press the
Key several times to
display alh1 (ALH1).
4
Set the parameter with the
If required, use the
set the hysteresis for alh2 (ALH2) (Alarm 2 Hysteresis), alh3 (ALH3) (Alarm 3 Hysteresis), and
alh4 (ALH4) (Alarm 4 Hysteresis)
(The number of alarms that is supported depends on the model of Temperature Controller. Some of
the alarm parameters may not be displayed.)
(When finished, press the
Simplicity on the Worksite
4-10
Operating Display
(Level) Key
Initial Setting Level
Key.
Initial Setting Level
(Mode)
Keys.
Initial Setting Level
(Mode) Key and the
(Level) Key for at least 1 second to return to the operation display.)
Solutions Guide for FAQs: E5CC/E5EC
←in-t (IN-T) will be displayed to
show that the Initial Setting Level
has been entered.
alh1 (ALH1):
←Indicates the Alarm 1 Hysteresis parameter.
←Default setting is 0.2°C.
Change the set value
with the
Down) Keys
(Up and Down) Keys to repeat steps 3 and 4 and
(Up and