Table of Contents
Advertisement
Inject adhesive
from the back of the borehole without forming air voids
Setting the element
For detailed information on installation see instruction for use given with the package of the product.
09 / 2014
Inject the adhesive starting at the back of the hole, slowly withdrawing the
mixer with each trigger pull.
Fill holes approximately 2/3 full. It is required that the annular gap between
the anchor and the concrete is completely filled with adhesive along the
embedment length.
After injection is completed, depressurize the dispenser by pressing the
release trigger. This will prevent further adhesive discharge from the
mixer.
Overhead installation and/or installation with embedment depth h
250mm.
For overhead installation the injection is only possible with the aid of
extensions and piston plugs. Assemble HIT-RE-M mixer, extension(s) and
appropriately sized piston plug HIT-SZ. Insert piston plug to back of the
hole and inject adhesive. During injection the piston plug will be naturally
extruded out of the bore hole by the adhesive pressure.
Under water application: fill borehole completely with mortar.
Before use, verify that the element is dry and free of oil and other
contaminants.
Mark and set element to the required embedment depth untill working time
t
has elapsed.
work
For overhead installation use piston plugs and fix embedded parts with
e.g. wedges HIT-OHW.
Loading the anchor:
After required curing time t
The applied installation torque shall not exceed T
These pages are part of the Anchor Fastening Technology Manual issue September 2014
Hilti HIT-RE 500 mortar
with HIS-(R)N sleeve
the anchor can be loaded.
cure
max.
>
ef
583
Advertisement
Table of Contents
