TrekStor DataStation MAXI Z.UL User Manual page 52

7) Troubleshooting and correction
Why does the "n
window of the
It is likely that you have not entered all of the characters correctly. The letter
"O" is never included. Check to be sure you have used the "0" (zero) digit.
I registered a
appear in "
DataStation maxi z.ul
The
• Unplug the network cable from your
wait about 10 seconds, and plug it back in.
• If the status of your
after this action, please reboot your PC.
Why can't I put my Pc in the idle state or standby mode?
If you want to put your computer in the idle state or standby mode, you
must first unmount the
on the TrekStor NDAS Device Management symbol in the Info area of your
task bar and mark the
Select "u
nmount
Alternatively, in the options of the TrekStor NDAS Device Management,
you can activate the support for the idle state or the standby mode.
My DataStation maxi z.ul
Please check the following items:
• Is the power cable attached correctly?
• Is the status display (LED) on the switch or on the network connection of
your PC, to which the
flashing?
• Make sure that your firewall /antivirus software has been deactivated
before installation. Current antivirus software has a new feature
called Script Blocking. Make sure that this feature is deactivated before
EN
you continue. You must also allow the NDAS software protocol and the
necessary NDAS software to pass your firewall or virus scanner.
• If you are using a wireless LAN, make sure that you are connected to
the wireless router and that the signal strength is good. Go to the
website of the wireless router manufacturer and load the latest
firmware and the latest drivers for your wireless LAN card. Try to
connect the
router via the network cable and check to see if it works.
" button in the "ndaS
ext
DataStation maxi z.ul
DataStation maxi z.ul
"?
red
DataStation maxi z.ul
DataStation maxi z.ul
DataStation maxi z.ul
" in the menu.
DataStation maxi z.ul
DataStation maxi z.ul
device identification number
remain gray?
. Why does the status
could not be found in the network.
DataStation maxi z.ul
has a black status indicator.
directly to your wireless
– 52 –
"
does not change
. To do so, click
to be deactivated.
is connected,
,