TrekStor DataStation MAXI Z.UL User Manual page 44

"Stripe" (RaID0)
In the "s
triPe
maxi z.ul
which can be an advantage as far as speed is concerned.
Note: It is recommended to use only
of the same size in this mode. If you use hard disks of different sizes, you only have
twice (four times or eight times) the total size of the smallest
maxi z.ul
the Stripe system, so as to ensure continuous parallel writing.
Example: 1x DataStation maxi z.ul 160 GB + 1x DataStation maxi z.ul 250 GB
= 1x DataStation maxi z.ul 320 GB in the Stripe mode)
Note: The danger of losing data increases in the Aggregation and Stripe
modes, since it is not possible to read the data if one of the two hard disks is no
longer functioning.
"Mirroring" (RaID1)
The "m
irroring
data from a primary
DataStation maxi z.ul
of the primary
EN
DataStation maxi z.ul
a continuously up-to-date backup.
Note: When mirroring 2
memory of the primary and / or the smaller
at your disposal. This is required in a mirroring system, since the secondary
DataStation maxi z.ul
of the primary
Example: 1x DataStation maxi z.ul 160 GB + 1x DataStation maxi z.ul 250 GB
= 1x DataStation 160 GB in the mirroring system)
" coupling mode, you can combine 2 (4 or 8)
units. The data is written to both hard disks at the same time,
available in the Stripe system. This is a specified characteristic of
" coupling mode enables real-time mirroring of the
DataStation maxi z.ul
DataStation maxi z.ul
DataStation maxi z.ul
DataStation maxi z.ul
DataStation maxi z.ul
. The data is written as continuous copies
onto the secondary
, if changes or edits are made – much like
DataStation maxi z.ul
is available solely for backing up the data
.
– 44 –
DataStation
units
DataStation
to a secondary
, you have the