Advertisement
1.4LED Indicators
One "FDX"
LED
One
"1000"
LED
One "100"
LED
One "10"
LED
Note: When the Link/Act LED is ON, it
indicates that TEL9901G is connected to the
network successfully at the respective transfer
rate. When the Link/Act LED is blinking, it
indicates that TEL9901G is transmitting data.
2 Hardware Installation
Please install TEL9901G according to
the following steps:
1.
its power cord and remove the chassis
cover.
2.
DGE-530T card into the connector of any
available PCI Bus Master expansion slot.
Press the card firmly into the connector
such that the card ' s contacts are fully
seated in the connector.
3.
secures the card to the computer chassis
the PCI slot of the
main-board, MAX 4 watts
consumption
ON indicates that TEL9901G is
working under full duplex mode
Indicates status of 1000Mbps
Link/Act
Indicates status of 100Mbps
Link/Act
Indicates status of 10Mbps
Link/Act
Shut down your computer, unplug
Insert the contact edge of the
Install the bracket screw that
4
Advertisement
