Advertisement
All manuals and user guides at all-guides.com
1.4LED Indicators
One "FDX"
ON indicates that TEL9901G is
LED
working under full duplex mode
One
Indicates status of 1000Mbps
"1000"
Link/Act
LED
One "100"
Indicates status of 100Mbps
LED
Link/Act
One "10"
Indicates status of 10Mbps
LED
Link/Act
Note: When the Link/Act LED is ON, it
indicates that TEL9901G is connected to the
network successfully at the respective transfer
rate. When the Link/Act LED is blinking, it
indicates that TEL9901G is transmitting data.
2 Hardware Installation
Please install TEL9901G according to
the following steps:
1.
Shut down your computer, unplug
its power cord and remove the chassis
cover.
2.
Insert the contact edge of the
DGE-530T card into the connector of any
available PCI Bus Master expansion slot.
Press the card firmly into the connector
such that the card ' s contacts are fully
seated in the connector.
3.
Install the bracket screw that
secures the card to the computer chassis
the PCI slot of the
main-board, MAX 4 watts
consumption
4
Advertisement
