Blade - Makita LS1216 Technical Information

R
epair
[4] ADJUSTMENT
[4]-5. Laser (for LS1216L only)
(1) Remove M10x20 Hex flange head bolt, Outer flange, Inner flange and Blade.
Then separate Safety cover section from Blade case complete. (Fig. 84)
(2) Remove Protector. (Fig. 85)
(3) Place Flat washer 16 on Spindle (Fig. 86) and fasten 1R315 and Flat washer 16 by gently tightening M10x20 Hex flange
head bolt as illustrated in Fig. 87.
(4) Plug the tool to turn on the laser beam.
WARNING: Do not touch Operation switch. (Fig. 88)
(5) Press the upper position (I) of Switch for Laser. (Fig. 88)
(6) Slide the position of M5x24 Thumb screw to the center of Laser cover so that a laser beam can be moved as widely as
possible to right or left. (Fig. 89)
(7) Move 1R315 to low side and align the laser beam with 1R315 by adjusting M4x6 Hex socket set screw A as drawn in
Fig. 90.
(8) Move 1R315 to high side and align the laser beam with 1R315 by adjusting M4x6 Hex socket set screw B as drawn in
Fig. 91.
Fig. 84
Blade case
complete
M10x20 Hex flange head bolt
Fig. 86
1mm
Spindle
Fig. 89
M5x24 Thumb screw
Laser cover
(9) Slide the position of M5x24 Thumb screw either right or left to align the laser beam and the groove of 1R315.
And tighten M5x24 Thumb screw.
(10) Move 1R315 to low side and align the laser beam and the groove of 1R315 by adjusting M4x6 Hex socket set screw A
(Fig. 90)
(11) Move 1R315 to high side and align the laser beam and the groove of 1R315 by adjusting M4x6 Hex socket set screw B
(Fig. 91)
(12) Do fine adjustment by repeating the process (9), (10) and (11).
Safety cover
section
Fig. 87
16mm
26mm
Flat washer 16 as
a repairing tool
(Part No. 253771-0)
Fig. 90
Bring the laser beam
near this groove.
1R315
Fig. 85
Protector
M10x20 Hex
flange head
bolt
1R315
Fig. 91
M4x6 Hex
socket set
screw A
Fig. 88
Switch for
laser
Operation switch
M4x6 Hex socket set
screw B
Bring the laser beam
near this groove.
1R315
P 23/ 35