Installing Or Removing The Blade - Makita DPB181 Instruction Manual

Lighting up the lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
1
► 1. Lamp
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out just after releasing the trigger.
NOTICE:
• Do not apply impact to the lamp, which may cause
damage or shorted service time to it.
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
• Do not use thinner or gasoline to clean the lamp.
Such solvents may damage it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.

Installing or removing the blade

CAUTION:
• Oil on the blade can cause the blade to slip or
come off unexpectedly. Wipe off all excess oil
with a cloth before installing the blade.
• Always wear protective gloves when handling
the blade.
• Use caution when handling the blade to avoid
cut by the sharp edge of the blade teeth.
• Keep your body away from the blade area when
checking the blade movement.
• When turning the blade tightening lever clock-
wise to release the tension on the blade, point
the tool downward because the blade may come
off unexpectedly.
► 1. Tighten 2. Loosen 3. Lever
To install the blade:
1. Turn the blade tightening lever clockwise until it
stops to loosen the wheel.
2. Match the direction of the arrows on the blade and
on the wheels.
2
► 1. Lower holder 2. Upper holder
1
► 1. Bottom bearing
6 ENGLISH
3
1
2
1