Knob - Makita LS1216 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Positive lock mechanism of Turn base (cont.)
ASSEMBLING
Note: Assemble Grip 50 to Miter lock plate B complete (Fig. 52)
so that the notch of Cam portion faces the upper side.
[3]-7. Assembling of Square rod complete
Match both ends of Square rod complete with the notches
of Arm holder complete on condition that the notches are
on the closest position to the center of Turn base, and
tighten two M5x30 Hex bolts. (Fig. 53)
Note: Face the concave of Square rod complete to the
center of Turn base as drawn in Fig. 53.
[3]-8. Stopper pin
DISASSEMBLING
(1) Push Knob 20 to lock Blade case at highest elevation
angle.
Then remove M6x20 Hex socket head bolt for
securing Link plate. (Fig. 54)
(2) Lower Blade case slightly to hold Stopper pin, turn
Knob 20 counterclockwise a little.
Note: Do not remove Knob 20, or Stopper pin will not
be pulled.
(3) Remove Blade case section according to the step
shown in the clause [3]-1.
(4) Remove Knob 20 from Stopper pin, and then pull out
Stopper pin in the direction designated with black
arrow in Fig. 54.
ASSEMBLING
Take the disassembling step in reverse.
Note: Apply Makita grease SG No.00 to O ring 7 that
is fit into Stopper pin. Refer to Fig. 3.
Fig. 52
Miter lock plate B complete
notch of Cam portion
of Grip 50
Fig. 53
M5x30 Hex bolt (2pcs.)
notches of
Arm holder
complete
threaded holes of
Arm holder complete
Fig. 54
P 17/ 35
Miter lock plate A
Arm holder complete
Square rod center of
complete Turn base

Knob 20

Stopper pin
Link plate M6x20 Hex
complete socket head bolt
Flat washer 6
Ring 6