Yamaha YZF-R6TC Supplementary Service Manual page 24

Starter motor lead
Battery
Battery positive lead
Starter relay
Bolt
Turn signal relay
Fuse box
Pressure sensor
Tail / brake light
Tool kit
ECU
Wire harness
Battery negative lead
Battery band
Battery box
Starting circuit cut-off relay
CABLE ROUTING
Push the starter motor lead in the clamping sec-
tions (two points) or the battery box assembly and
secure it.
Install to the deepest position of the rib of the bat-
tery box assembly.
Fit in the plastic cover of rivet to the main unit after
assembly.
Make sure to clamp the wire harness. (Tighten it
until the clamp latchet stops.)
Insert the turn signal light relay to the back end of
the rib in the battery box assembly.
Hook of the battery box assembly shall hook on
the upper face of the fuse box. (It should not be put
on the side face.)
Set the immobilizer unit couplers (two units) in the
right side space of the tool kit.
17
SPEC