Safety Information - Ista ultego III smart plus Technical Description

Safety information

2 Safety information
The meter may only be used in building service engineering
systems and only for the applications described.
The local regulations (installation etc.) must be adhered to.
Adhere to the operating conditions according to the dial plate
during use. Non-adherence can cause hazards and the guaran-
tee will expire.
The meter is only suitable for circulating water in heating sys-
tems.
The meter is not suitable for drinking water.
Be aware of sharp edges on thread and measuring tube.
The meter is suitable for circulating water in heating systems.
Adhere to the AGFW requirements regarding circulating water
(FW510).
Do not lift the meter by the electronic unit or by the adapter
plate
.
Only personnel, trained in the installation and operation of me-
ters in heating and cooling systems, may install and remove the
meter.
Only install or remove the meter when the pipes are pressure-
less.
After installing the meter, check the leak-tightness of the sys-
tem.
Guarantee and calibration validity will lapse if the calibration
relevant security seal is broken.
Only clean the meter from outside with a soft, lightly wetted
cloth. Do not use any spirit or cleaning solvent.
As far as disposal is concerned, the meter is a waste electronic
appliance in the sense of European Directive 2012/19/EU
(WEEE) and it must not be disposed of as domestic waste. The
relevant national, legal regulations must be observed as the
appliance must be disposed of via the channels provided for this
purpose. The local and currently valid legislation must be ob-
served.
The meter contains lithium batteries. Do not dispose of the
meter and the batteries with domestic waste. Observe the local
stipulations and laws on disposal.
5/26