Advertisement
Jumper
Setting
Description
PS2JJSB_PWR1
1
2
(see p.2/p.3 item 22)
gj|g|
+ 5V
2_3
Short pin2, pin3 to enable
• [o
T
oj
+5VSB (standby) for PS/2 or
+5VSB
U®
5
wake up events.
Note: To enable +5VSB, it requires 2 Amp and higher standby current.
CLRCMOS1
(see p.2/p.3 item 17)
Solder points
D i s c o n n e c t the power
cord, then short the sol-
der points to clear CMOS
by using metal material,
eg., a paper clip.
2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps
Connector
over these connectors.
Figure
Description
FDD connector
(33-pin FLOPPY1)
(see p.2/p.3 item 10)
I
I В I • I I 1 I
PiNl
F L C
I I 1 I I I I I D !
m\
FLOPPY1
Red Marking
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1)
(see p.2/p.3 item 7)
Secondary IDE connector (Black)
(39-pin IDE2)
(see p.2/p.3 item 8}
connect this end (Blue)
to the motherboard '
connect this end (Black)
to the IDE devices
80 Pin ATA 100/133 cable
Note: To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB header
(9- pin USB45)
(see p.2/p.3 item 13)
l.iB P V . <
4
AS Rock I/O™ already
provided 4 default USB ports.
If the 4 USB ports on the rear
panel are not sufficient, an
USB header is available for 2
additional USB ports.
Infrared module connector
(5-pin IR1)
(see p.2/p.3 item 14)
This connector supports an
optional wireless transmitting
and receiving infrared module.
o>
С
Advertisement
