Advertisement
compliance wake up events; supports jumperfree; SMBIOS
2.3.1 support; CPU irequency stepless control (only for
advanced users' reference)
OS:
Windows 98SE / ME / 2000 / XP compliant
While CPU overheat is detected, the system will automatically shutdown and
the power button on the chassis will be disabled. Please check if the CPU fan on
the motherboard functions properly before you resume the system.
Although G Pro/GV Pro offers CPU frequency stepless control, it is not
recommended to perform over clocking. Frequencies other than the recommended
CPU bus frequency may cause the instability of the system or damage the CPU.
2.
Installation
Pre-installation Precautions
Take note of the following precautions before you install motherboard components or change any
motherboard settings.
1. Unplug the power cord from the wall socket before touching any component. Failure to
do so may cause severe damage to the motherboard, peripherals, and/or components.
2. To avoid damaging the motherboard components due to static electricity, NEVER place your
motherboard directly on the carpet or the like. Also remember to use a grounded wrist strap or
touch a safely grounded object before you handle components.
3. Hold components by the edges and do not touch the ICs.
4. Whenever you uninstall any component, place it on a grounded antistatic pad or in the
bag that comes with the component.
2.1
CPU Installation
Step 1.
Unlock the socket by lifting the lever up to а 90° to 100° angle.
Step 2.
Position the CPU directly above the socket such that its marked corner
matches the base of the socket lever.
Step 3.
Carefully insert the CPU into the socket until it fits in place.
The CPU fits only in one correct orientation. DO NOT force the CPU into the socket
to avoid bending of the pins.
Step 4.
When the CPU is in place, press it firmly on the socket while you push
down the socket lever to secure the CPU. The lever clicks on the side tab
to indicate that it is locked.
Step 5.
Install CPU fan and heatsink. For proper installation, please kindly refer to
the instruction manuals of your CPU fan and heatsink vendors.
2.2 Installation of Memory Modules (DIMM)
SDRAM (Synchronous DRAM) DIMM (Dual In-line Memory Module) has 168 pins and
DDR (Double Data Rate) SDRAM DIMM has 184 pins. The 168-pin SDRAM DIMM
Advertisement
