Advan 240-030-970 User Manual page 6

disconnect the cord, unscrew the plug first then, pull the cord out by the
plug. Never pull the cord itself.
8. To avoid electric shock, avoid removing the control unit covers.
9. Do not attempt internal repairs or adjustments not specifically detailed
in this operating manual.
10. Pay close attention to the care and cleaning instructions in this manual.
A deviation may cause damage (refer to the "Cleaning" section).
11 Do not sterilize the display.
12. Use appropriate caution to prevent contact with fluids if the unit is being
used with a power supply in patient environments.
13. Federal law (United States of America) restricts this device to sale by, or
on the order of, a physician.
Cautions
1. Plug the AC adapter in to a grounded power outlet.
2. Use only the proprietary Vision Elect WHDTV power supply (P/N 240-
030-90, Manufacturer: JEC Korea, Model No: JMW110KA2400F07)
for the Vision Elect WHDTV display (model 240-030-970). Completely
3. Connect equipment to a receptacle labeled "Hospital Only" or "Hospital
Grade" to achieve grounding reliability.
4. To connect to an international power supply, use an attachment plug
appropriate for the power outlet
. Power off the unit when it is not in use.
6. Remove the power module and connection when transporting the unit.
8. Handle the display with care. Do not strike or scratch the screen.
9. Never operate the unit right after having been transported from a cold
location directly to a warm location.
10. Do not expose the display to moisture or apply liquid cleaners directly
to the screen. Spray the cleaning solution into a soft cloth and clean
gently.
11. Allow adequate air circulation to prevent internal heat buildup.
12. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials
(curtains, draperies) that may block the ventilation slots. The display is
cooled by natural convection and has no fan.
13. Do not install the unit near sunlight, excessive dust, mechanical
vibration, or shock.
14. Do not operate the unit in a vertical position. The unit is designed for
operation in a horizontal position.
6