T+A Solitaire CWT 1000-40 User Manual page 26

Amplifier
Cable
Standard - connections
Bi - Wiring
The CWT 1000-40 can be connected to any amplifier designed for a 4 Ohm
speaker load. However, if you wish to exploit the full sound potential of these
speakers, we recommend power amplifiers which are capable stable of
supplying high currents.>10 Ampere.
 Loudspeaker binding posts and loudspeaker cables can carry dangerously
high voltages. Be sure to switch off the amplifier before carrying out any
wiring work.
 The cables employed in any Hi-Fi system have a crucial influence on the
sound of the system as a whole. For this reason
range of cables which includes the ideal type for every application. These
cables are designed to match the special characteristics of our
loudspeakers. Please note that all the cables used should be the same
length!
In the standard wiring arrangement only one speaker cable is required for
each loudspeaker. The linking bridges between Bass and Mid / High must be
left in place.
In bi-wiring and bi-amping arrangements the cables bridging of the woofer

(Bass) and mid/high (Mid/High) input terminals must be removed!
Bi-wiring provides better sound by separating the bass (Bass) signal and
mid-range/treble signals (Mid/High). Two speaker cables are required for
each loudspeaker.
If your power amplifier has two loudspeaker outputs ( A and  B), the
speakers are connected as shown in the illustration below; If the power
amplifier has outputs for only one pair of loudspeakers, connect both cables
to these outputs in parallel.
26
has developed its own