T+A Solitaire CWT 1000-40 User Manual page 23

 Install the front spikes first. One person will slightly tilt the CWT 1000-40
backwards (Fig. 5), while another person will remove the furniture glides and
attach the spikes as described in "Fitting the spikes in detail" (Fig. 7).
 After the spikes are mounted, the floor contact plates must be positioned
under the spikes on the floor.
 Slowly lower the speaker until the spikes are on the floor contact plates. If
necessary, correct the position of the floor contact plates again before
completely removing the speakers.
The small recess in the floor contact plate centers the spike.

In the second step the rear spikes are fitted (Fig. 6).
 The assembly is carried out as described above.

Take special care that the CWT 1000-40 does not slip away on the floor contact
plates. Tilt the speaker only so far that the spikes can be mounted.
23
Fig. 5
Fig. 6