Tunstall Fall Detector User Manual page 9

Radio Approval Notices
Australia
The Fall Detector operates on a frequency of 312MHz and is
certified approved by TRL Compliance to AS/NZS 4268:2003
Canada
Canadian Certification Approvals Number
IC: 1231A-66004A
USA
Federal Communications Commission (FCC) notices
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
Installation and User Guide
• Consult the dealer or an experienced
radio/TV technician for help.
Fall Detector Radio Trigger
Model Numbers
66004/01
66004/02
66004/03
66004/04
FCC ID: G2X-66004A
This Device complies with Part 15 of
the FCC Rules.
Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause undesired
operation.
Warning
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
Page 9 of 10