Using The Warming Drawer; Control Knob; On Signal Light; Moisture Selector - Monogram ZJ7000 Owner's Manual

The warming drawer controls are hidden with
Control
the drawer shut. Open the drawer. The controls
Knob
are on the right side of the front frame.
To use the warming drawer, press the ON/
OFF switch to the ON position.
Slide the moisture selector control to the open
or closed setting. (See the Moisture Selector
section.)
Turn the control knob clockwise to the desired
setting.
The ON signal light is located below the ON/
ON Signal
OFF switch and glows when the ON/OFF
Light
switch is in the ON position. It stays on until the
ON/OFF switch is moved to the OFF position.
The moisture selector is located on the inside
Moisture
front of the drawer.
Selector
To keep foods moist, slide the moisture
selector control away from the control knob.
This closes the vent and seals the moisture
inside the drawer. With the vent closed hot
foods stay moist and soft.
In this setting condensation may occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture
selector control to the right towards the control
knob. This opens the vents and allows the
moisture to escape.
With the vents open, it is normal for moisture
to collect on surfaces above the warming
drawer.
49-80384-6
PROOF . . . 75–95°F.
LOW . . . . . 140–160°F.

Using the Warming Drawer

MED . . . . . 160–195°F.
HIGH . . . . 195–230°F.
The ON signal light is visible through the light
viewer in the drawer front panel when the
drawer is closed. This is a reminder that the
heat is on.
Electric Warming Drawer
7