Troubleshooting Tips - Monogram ZJ7000 Owner's Manual

Before you
call for service
12
Save time and money! Review the charts on the following pages first and you may not need to
call for service.
Problem Possible Cause
Warming drawer A fuse in your home may be blown
will not work or the circuit breaker tripped.
Warming drawer not plugged in.
Warming drawer controls
improperly set.
Drawer does not Ball bearings are out of alignment.
slide smoothly
or drags
Drawer over-loaded or load
unbalanced.
Excessive Uncovered foods.
condensation
Temperature setting too high.
Incorrect Moisture Selector setting.
No heat in the Room temperature may prevent the
proof setting thermostat from tripping on.
Food dries out Moisture escaping.

Troubleshooting Tips

Electric Warming Drawer
What To Do
Replace the fuse or reset the circuit breaker.
Plug in.
See the Using the Warming Drawer section.
Fully extend the drawer and push it all the
way in. See the Care and Cleaning section.
Reduce weight to less than 50 pounds.
Redistribute drawer contents.
Cover food with lid or aluminum foil.
Reduce temperature setting.
Set the Moisture Selector to the open vent
setting to allow venting.
Turn the knob to LOW then back to PROOF.
Cover food with lid or aluminum foil.
49-80384-6