Setting Up The Ground Speed Control Levers - Simplicity 7800269 Initial Setup Manual

Axion / 150Z Series
Setting Up the Ground
Speed Control Levers
1. Loosen (do not remove) the hardware securing the
ground speed control levers to the lever bases.
2. Raise the levers, aligning the upper hole in each lever
with the upper slotted hole in the lever base.
20-23 N.m.
15-17 ft. lbs.
Figure 7. Setting up the ground speed levers
8/2008
C
A
11
3. Install the noted hardware as shown in Figure 7.
Tighten all hardware. Torque to 15-17 ft. lbs. (20-23
N.m.).
Note: Ground speed control levers must be adjusted
prior to use. Refer to the Section 'Ground Speed
Control Lever Adjustment' in the Operator's Manual.
A
B
B
C
5/16-18
5/16-18
x 1-3/4
TP 300-5412---ZT-SN