Battery Activation & Installation - Simplicity 7800269 Initial Setup Manual

Axion / 150Z Series
Battery Activation &
Installation
Charge Battery
1. Tip the seat forward to access the battery.
2. Remove the battery from the battery compartment,
and place the battery on a level, non-concrete sur-
face.
Note: When removing the battery cables from the bat-
tery, always remove the negative (-) cable first.
3. To charge the battery, follow the instructions provided
by the battery charger manufacturer as well as all
warnings included in the safety rules section of this
document. Charge the battery at 6-10 amps for 1
hour. Do not charge at a rate higher than 10 amps.
See Figure 2.
Figure 2. Charging the battery
WARNING
Corrosion hazard.
Batteries contain acid. Always keep the
battery upright and do not spill the
electrolyte. Avoid contact with skin and
eyes.
Explosion hazard.
Changing the battery produces explosive
hydrogen gas. Only charge the battery in a
well ventilated area, away from any ignition
source such as a water heater, electric
motor, or a lit cigarette.
Wear Protective Equipment
Always wear gloves and safety glasses
when handling the battery and battery
cables.
TP 300-5412---ZT-SN
Install Battery
1. Install and secure the battery in the battery compart-
ment (Figure 3).
2. Connect the red positive battery cable (A, Figure 4) to
the positive battery terminal, then cover the positive
battery terminal with the terminal cover.
3. Connect the black negative battery cable (B) to the
negative battery terminal.
Figure 3. Installing the battery
B
Figure 4. Installing the battery cables
8
A
8/2008