Uncrating - Simplicity 7800269 Initial Setup Manual

Axion / 150Z Series

Uncrating

1. Using a reciprocating utility saw or equivalent, cut
crate away from bottom skid. Remove crate. Remove
plastic wrap.
2. Cut any banding securing the unit.
IMPORTANT NOTE
When cutting crate from bottom skid,
use caution around tires and mower
rollers.
C
Figure 1. Pushing the rider
8/2008
3. Locate the transmission release levers (C, Figure 1)
at the rear of the unit.
4. Pull both levers back and down to release the trans-
missions (position B, Figure 1).
5. Pull the ground speed control levers in to their DRIVE
positions, and disengage the parking brake.
The rider can now be pushed by hand.
6. After moving the rider, set the ground speed control
levers to START/PARK, engage the parking brake,
and push both transmission release levers forward to
re-engage the transmissions (position A, Figure 1).
DO NOT TOW RIDER
Towing the unit will cause transmission dam-
age. Do not use another vehicle to push or
pull this unit. Do not use this unit to push or
pull another vehicle or object.
A
B
7 TP 300-5412---ZT-SN